All the printed parts required to build your RepRap Mendel, complete with Wade’s extruder. Every part is printed on one of our Mendels using the EckerTech Inc. heated build plate (to prevent warping) and a .406mm nozzle (to improve definition and structural integrity).

Note: the pulley versions included in this package are the 3 nophead drive pulleys with the grub-screw modification and the nophead z-pulleys with bottom rim.

As an added bonus we are including the hobbed bolt for the Wade’s extruder.

Here is the list of Mendel parts included in this package:

• 4 - Bed Spring
• 4 - Circuit Board Bracket - M3
• 2 - Circuit Board Spacer - M4
• 3 - Drive Pulley (nophead's design)
• 6 - Frame Vertex
• 2 - X-180 Z-Bearing Plate
• 2 - X-360 Z-Bearing Plate
• 2 - X-360 Z-Bearing Plate Mirror
• 2 - X-Axis Side Plate Nut Jig
• 6 - X-Bar Clamp - M3
• 4 - X-Bar Clamp - M4
• 2 - X-Carriage Belt Clamp
• 1 - X-Carriage Lower
• 1 - X-Carriage Upper
• 2 - X-End Bracket
• 1 - XLR Bracket
• 2 - X-Motor Bracket Spacer
• 4 - X-Vert Drive Nut Trap
• 2 - X-Vert Drive Side Plate 180 End
• 2 - X-Vert Drive Side Plate 360 End
• 10 - Y-Bar Clamp
• 2 - Y-Bearing 180 Inner
• 1 - Y-Bearing 180 Outer Left
• 1 - Y-Bearing 180 Outer Right
• 2 - Y-Bearing 360 Inner
• 1 - Y-Bearing 360 Outer Left
• 1 - Y-Bearing 360 Outer Right
• 2 - Y-Belt Clamp
• 1 - Y-Idler Bracket
• 1 - Y-Motor Bracket
• 1 - Z-Axis Opto Spring
• 4 - Z-Bar Top Clamp
• 2 – Z-Pulley (nophead’s Design)
• 2 – Z-Pulley Bottom Rim (nophead's Design)
• 2 - Z-Leadscrew Base
• 2 - Z-Leadscrew Base Bar Clamp
• 1 - Z-Motor Bracket
• 1 - Z-Opto Bracket
• 1 - Z-Tensioner
• 1 - Bed Height Spacer, 31mm
• 1 - Belt Plate Jig

Here is the list of Wade's Extruder parts included in this package:

• 1 - Extruder Block
• 1 - Extruder Idler Block
• 1 - Small Gear
• 1 - Big Gear

The hobbed bolt kit comes with:

• 1 - m8 bolt
• 3 - m8 nuts
• 1 - m8 washer

For installation instructions, see Alternate Wade's Extruder Hobbed Bolt Installation.
For examples of our print resolution and a comparison of the .5mm nozzle versus the .406mm nozzle, please click here.